Navigation: Toolbars >
Toolbars - Validation
Use the Validation toolbar to locate and solve common glyph problems. It can be toggled on and off using the F7 shortcut key (or Show glyph validation report button on the Glyph toolbar), but is only available in the Glyph Edit window.
Note: Because validation can be very time-consuming, real-time glyph problem detection will be disabled for too complex glyphs. The limits for real-time glyph validation are set on the Validation tab of the Options dialog.
Red marks in the Glyph Edit window will show the position of the located problems.
Not every problem should be classified as an error, it is the designer's decision to correct or ignore potential problems. Double-click on a reported problem to focus the problematic point or contour. There are several buttons on the Validation toolbar that will perform actions that will automatically solve some specific problems.
Enable real-time glyph problem detection
Use this button to enable and disable real-time glyph problem detection.
When real-time validation is not enabled, use this button to revalidate the glyph.
Use this button to save the report to file.
Show intersecting components and contours
Intersections will be shown when this button is enabled and is down. Red crosses in the Glyph Edit window will show the position of the intersections.
Show warning points
Warning points will be shown when this button is enabled and is down. Red bullets in the Glyph Edit window will show the position of the located problems.
Correct contour directions
Use this button to correct the direction of all misoriented contours in a simple glyph. This button is only enabled when contour direction problems are detected.
Remove duplicate components and contours
This button will remove duplicate components from a composite glyph and will remove duplicate contours from a simple glyph.
Remove empty components and contours with one and two points
This button will remove empty components from a composite glyph and will remove contours with one and two points from a simple glyph.
Remove redundant points
Press this button to remove all redundant points.
Add on-curve extremes
Press this button to add on-curve extremes. This feature will add global or local extremes, as customized through the Options window.
Note: The Validation features are not available in the Home Edition of FontCreator.